Wall-mode instability in plane shear flow of viscoelastic fluid over a deformable solid

Chokshi, Paresh and Bhade, Piyush and Kumaran, V (2015) Wall-mode instability in plane shear flow of viscoelastic fluid over a deformable solid. In: PHYSICAL REVIEW E, 91 (2).

PDF phy_rev_91-2_2015.pdf - Published Version Restricted to Registered users only Download (582kB) | Request a copy

Abstract

The linear stability analysis of a plane Couette flow of an Oldroyd-B viscoelastic fluid past a flexible solid medium is carried out to investigate the role of polymer addition in the stability behavior. The system consists of a viscoelastic fluid layer of thickness R, density rho, viscosity eta, relaxation time lambda, and retardation time beta lambda flowing past a linear elastic solid medium of thickness HR, density rho, and shear modulus G. The emphasis is on the high-Reynolds-number wall-mode instability, which has recently been shown in experiments to destabilize the laminar flow of Newtonian fluids in soft-walled tubes and channels at a significantly lower Reynolds number than that for flows in rigid conduits. For Newtonian fluids, the linear stability studies have shown that the wall modes become unstable when flow Reynolds number exceeds a certain critical value Re c which scales as Sigma(3/4), where Reynolds number Re = rho VR/eta, V is the top-plate velocity, and dimensionless parameter Sigma = rho GR(2)/eta(2) characterizes the fluid-solid system. For high-Reynolds-number flow, the addition of polymer tends to decrease the critical Reynolds number in comparison to that for the Newtonian fluid, indicating a destabilizing role for fluid viscoelasticity. Numerical calculations show that the critical Reynolds number could be decreased by up to a factor of 10 by the addition of small amount of polymer. The critical Reynolds number follows the same scaling Re-c similar to Sigma(3/4) as the wall modes for a Newtonian fluid for very high Reynolds number. However, for moderate Reynolds number, there exists a narrow region in beta-H parametric space, corresponding to very dilute polymer solution (0.9 less than or similar to beta < 1) and thin solids (H less than or similar to 1.1), in which the addition of polymer tends to increase the critical Reynolds number in comparison to the Newtonian fluid. Thus, Reynolds number and polymer properties can be tailored to either increase or decrease the critical Reynolds number for unstable modes, thus providing an additional degree of control over the laminar-turbulent transition.

Item Type:	Journal Article
Publication:	PHYSICAL REVIEW E
Publisher:	AMER PHYSICAL SOC
Additional Information:	Copy right for this article belongs to the AMER PHYSICAL SOC, ONE PHYSICS ELLIPSE, COLLEGE PK, MD 20740-3844 USA
Department/Centre:	Division of Mechanical Sciences > Chemical Engineering
Date Deposited:	19 Mar 2015 12:06
Last Modified:	19 Mar 2015 12:06
URI:	http://eprints.iisc.ac.in/id/eprint/51033

Actions (login required)

View Item