Padmarajaiah, SK and Ramaswamy, Ananth (2002) A finite element assessment of flexural strength of prestressed concrete beams with fiber reinforcement. In: Cement and Concrete Composites, 24 (2). pp. 229-241.
![]() |
PDF
A_finite_element_assessment_of_flexural.pdf - Published Version Restricted to Registered users only Download (367kB) | Request a copy |
Abstract
This paper presents an assessment of the flexural behavior of 15 fully/partially prestressed high strength concrete beams containing steel fibers investigated using three-dimensional nonlinear finite elemental analysis. The experimental results consisted of eight fully and seven partially prestressed beams, which were designed to be flexure dominant in the absence of fibers. The main parameters varied in the tests were: the levels of prestressing force (i.e, in partially prestressed beams 50% of the prestress was reduced with the introduction of two high strength deformed bars instead), fiber volume fractions (0%, 0.5%, 1.0% and 1.5%), fiber location (full depth and partial depth over full length and half the depth over the shear span only). A three-dimensional nonlinear finite element analysis was conducted using ANSYS 5.5 [Theory Reference Manual. In: Kohnke P, editor. Elements Reference Manual. 8th ed. September 1998] general purpose finite element software to study the flexural behavior of both fully and partially prestressed fiber reinforced concrete beams. Influence of fibers on the concrete failure surface and stress-strain response of high strength concrete and the nonlinear stress-strain curves of prestressing wire and deformed bar were considered in the present analysis. In the finite element model. tension stiffening and bond slip between concrete and reinforcement (fibers., prestressing wire, and conventional reinforcing steel bar) have also been considered explicitly. The fraction of the entire volume of the fiber present along the longitudinal axis of the prestressed beams alone has been modeled explicitly as it is expected that these fibers would contribute to the mobilization of forces required to sustain the applied loads across the crack interfaces through their bridging action. A comparison of results from both tests and analysis on all 15 specimens confirm that, inclusion of fibers over a partial depth in the tensile side of the prestressed flexural structural members was economical and led to considerable cost saving without sacrificing on the desired performance. However. beams having fibers over half the depth in only the shear span, did not show any increase in the ultimate load or deformational characteristics when compared to plain concrete beams. (C) 2002 Published by Elsevier Science Ltd.
Item Type: | Journal Article |
---|---|
Publication: | Cement and Concrete Composites |
Publisher: | Elsevier Science |
Additional Information: | Copyright of this article belongs to Elsevier Science. |
Keywords: | Flexural strength;Partial depth fibers;Load–deflection response;fully/partially prestressed beams;High strength fiber reinforced concrete;Finite element analysis;Fiber bond-slip |
Department/Centre: | Division of Mechanical Sciences > Civil Engineering |
Date Deposited: | 04 Aug 2011 05:57 |
Last Modified: | 04 Aug 2011 05:57 |
URI: | http://eprints.iisc.ac.in/id/eprint/38941 |
Actions (login required)
![]() |
View Item |