Kumar, CS and Singh, T and Reddy, KPJ (2014) Investigation of the separated region ahead of three-dimensional protuberances on plates and cones in hypersonic flows with laminar boundary layers. In: PHYSICS OF FLUIDS, 26 (12).
PDF
phy_flu_26-12_2014.pdf - Published Version Restricted to Registered users only Download (19MB) | Request a copy |
Abstract
Heat transfer rate and pressure measurements were made upstream of surface pro-tuberances on a flat plate and a sharp cone subjected to hypersonic flow in a conventional shock tunnel. Heat flux was measured using platinum thin-film sensors deposited on macor substrate and the pressure measurements were made using fast acting piezoelectric sensors. A distinctive hot spot with highest heat flux was obtained near the foot of the protuberance due to heavy vortex activity in the recirculating region. Schlieren flow visualization was used to capture the shock structures and the separation distance ahead of the protrusions was quantitatively measured for varying protuberance heights. A computational analysis was conducted on the flat plate model using commercial computational fluid dynamics software and the obtained trends of heat flux and pressure were compared with the experimental observation. Experiments were also conducted by physically disturbing the laminar boundary layer to check its effect on the magnitude of the hot spot heat flux. In addition to air, argon was also used as test gas so that the Reynolds number can be varied. (C) 2014 AIP Publishing LLC.
Item Type: | Journal Article |
---|---|
Publication: | PHYSICS OF FLUIDS |
Publisher: | AMER INST PHYSICS |
Additional Information: | Copy right for this article belongs to the AMER INST PHYSICS, 1305 WALT WHITMAN RD, STE 300, MELVILLE, NY 11747-4501 USA |
Department/Centre: | Division of Mechanical Sciences > Aerospace Engineering(Formerly Aeronautical Engineering) |
Date Deposited: | 06 Feb 2015 14:54 |
Last Modified: | 06 Feb 2015 14:54 |
URI: | http://eprints.iisc.ac.in/id/eprint/50782 |
Actions (login required)
View Item |