Roads to ultrathin silicon oxides

Morgen, P and Bahari, A and Robenhagen, U and Andersen, JF and Hansen, JK and Pedersen, K and Rao, MG and Li, ZS (2005) Roads to ultrathin silicon oxides. In: Journal Of Vacuum Science & Technology A, 23 (1). pp. 201-207.

PDF JVA000201.pdf - Published Version Restricted to Registered users only Download (139kB) | Request a copy

Abstract

Ultrathin gate dielectrics for complementary metal-oxide-semiconductor (CMOS) devices, with suitable structural and electrical properties, are crucial for the further development of silicon based microelectronics. The effective (SiO2-equivalent) thickness of 10 A or below needed in the next generations of CMOS devices has been found too low to prevent tunneling. and leakage. with current processes for SiO2 based gate insulators. Before abandoning SiO2, completely however. there are good reasons to look for improved procedures or alternative processes to grow or form ultrathin SiO2 films on silicon, and possible improvements through the controlled addition of nitrogen. The present article initially describes an attempt to grow ultrathin oxides in a furnace. but this was limited to 50-Angstrom-thick layers or above. It then unveils some particularly simple. easily controlled, low-thermal budget, low-pressure based processes for thinner oxide layers, which have not been met earlier. These later processes are all done in an ultrahigh vacuum (UHV) based environment, starting from a clean and perfectly ordered Si surface. Thus we formed the thinnest possible (approximate to4 Angstrom) uniformly covering oxide layers on the Si(111) and Si(001) surfaces. They are made very simply from cycles of oxygen adsorption at room temperature and short anneals, and are self-saturating at this thickness. Following these processes we explored isothermal methods in UHV at low temperatures and pressures. Such processes, at low pressures. were found to lead to a universal, self-limiting growth of an approximately 7-Angstrom-thick oxide at a range of temperatures between 300 and 700 degreesC. Further, up to about 10 Angstrom oxides are grown in a series of steps. in each of which a layer of freshly deposited Cs on top of already grown oxide is retaining oxygen on this otherwise passivated surface. The Cs layer also catalyzes oxidation during a subsequent rapid annealing step. Higher thicknesses (up to 50 Angstrom) are obtained by using a precursor layer of Cs-oxide formed in alternating Cs and oxygen dosing processes, which is converted into SiO2, by heating. The present investigations are focused on structural properties of the systems studied with the use of electron spectroscopy, mainly photoemission with synchrotron radiation. in UHV. (C) 2005 American Vacuum Society.

Item Type:	Journal Article
Publication:	Journal Of Vacuum Science & Technology A
Publisher:	American Vacuum Society
Additional Information:	Copyright of this article belongs to American Vacuum Society.
Keywords:	Thermal-Oxidation;Electronic-Structure;Sio2/Si Interface;Thin Oxides;Dry Oxygen;Surfaces;Si(111);Growth;Nitride;Layer
Department/Centre:	Division of Physical & Mathematical Sciences > Instrumentation Appiled Physics
Date Deposited:	10 Feb 2010 07:15
Last Modified:	19 Sep 2010 04:56
URI:	http://eprints.iisc.ac.in/id/eprint/17307

Actions (login required)

View Item