Dry sliding wear behavior of $Al_{2}O_{3}$ fiber reinforced aluminum composites

Iwai, Y and Honda, T and Miyajima, T and Iwasaki, Y and Surappa, MK and Xu, JF (2000) Dry sliding wear behavior of $Al_{2}O_{3}$ fiber reinforced aluminum composites. In: Composites Science and Technology, 60 (09). pp. 1781-1789.

PDF http___www.sciencedirect.com_science0f7fb5b&ie=_sdarticle.pdf - Published Version Restricted to Registered users only Download (4MB) | Request a copy

Abstract

Dry sliding wear behavior of die-cast ADC12 aluminum alloy composites reinforced with short alumina fibers were investigated by using a pin-on-disk wear tester. The Al2O3 fibers were 4 mu m in diameter and were present in volume fractions (T-f)ranging from 0.03 to 0.26, The length of the fiber varied from 40 to 200 mu m. Disks of aluminum-alumina composites were rubbed against a pin of nitrided stainless steel SUS440B with a load of 10 N at a sliding velocity of 0.1 m/s. The unreinforced ADC 12 aluminum alloy and their composites containing low volume fractions of alumina (V-f approximate to 0.05) showed a sliding-distance-dependent transition from severe to mild wear. However, composites containing high volume fractions of alumina ( V-f > 0.05) exhibited only mild wear for all sliding distances. The duration of occurrence of the severe wear regime and the wear rate both decrease with increasing volume fraction. In MMCs the wear rate in the mild wear regime decreases with increase in volume fraction: reaching a minimum value at V-f = 0.09 Beyond V-f = 0.09 the wear rate increases marginally. On the other hand, the wear rate of the counterface (steel pin) was found to increase moderately with increase in V-f. From the analysis of wear data and detailed examination of (a) worn surfaces, (b) their cross-sections and (c) wear debris, two modes of wear mechanisms have been identified to be operative, in these materials and these are: (i) adhesive wear in the case of unreinforced matrix material and in MMCs with low Vf and (ii) abrasive wear in the case of MMCs with high V-f.

Item Type:	Journal Article
Publication:	Composites Science and Technology
Publisher:	Elsevier Science
Additional Information:	Copyright of this article belongs to Elsevier Science.
Department/Centre:	Division of Mechanical Sciences > Mechanical Engineering
Date Deposited:	01 Jun 2009 08:37
Last Modified:	19 Sep 2010 04:55
URI:	http://eprints.iisc.ac.in/id/eprint/17051

Actions (login required)

View Item